使输送带更好的为我们的生产服务，下面我们就来说一个问题，输送带皮带呈现打滑现象怎么处理？

To make the conveyor belt better serve our production, let's talk about a problem. How to deal with the slippage of the conveyor belt?

1、发动过快也会导致打滑。在这个时候，它能够慢慢开始。如果采用鼠笼式电机，经过两次微动后即可发动，也能有效克服打滑现象。

1. Starting too fast can also cause slipping. At this time, it can start slowly. If the squirrel cage motor is used, it can be started after two micro movements, which can also effectively overcome the slip phenomenon.

2、初始张力过小。皮带离开滚筒处的张力不行，导致皮带打滑。处理方法是调理张力设备，添加初始张力。

2. The initial tension is too small. The tension at the place where the belt leaves the drum is not good, causing the belt to slip. The treatment method is to adjust the tension equipment and add the initial tension.

3、如果山东输送带皮带的负荷过载，超过电动机的负荷就会打滑。因此，打滑的有利一面是维护电动机。否则，长期运转会烧坏电机。但对于手术来说，这是一次滑倒事端。

3. If the load of Shandong conveyor belt is overloaded, it will slip if it exceeds the load of the motor. Therefore, the advantage of slipping is to maintain the motor. Otherwise, long-term operation will burn out the motor. But for surgery, it was a slip.

4、尾滚柱轴承损坏不能转动，或上下惰轮轴承损坏，转动不太大。形成损坏的原因是飞机尾部漂浮下沉过多，损坏或不灵活的部件没有及时修补和替换，添加了阻力，形成打滑。

4. The tail roller bearing is damaged and cannot rotate, or the upper and lower idler bearings are damaged and do not rotate too much. The reason for the damage is that the tail of the aircraft floats and sinks too much, and the damaged or inflexible parts are not repaired and replaced in time, adding resistance and causing slippage.

5、驱动滚筒与输送带之间的摩擦力不行，导致打滑。其不想要的状况大多是输送带有水或环境潮湿。处理方法是在滚筒中参加一些松香粉。可是，不要用手吹设备。

5. The friction between the drive drum and the conveyor belt is not good, resulting in slipping. Most of the unwanted conditions are water in the conveyor belt or wet environment. The treatment method is to add some rosin powder in the roller. However, do not blow the equipment by hand.

我们在安装或维修更换输送带的过程中，须控制好胶接后的输送带的总长度。须严格管理输送带胶接施工过程，抓好施工细节，确保接头质量。更多相关内容就来网站http://www.huafengxiangsu.com咨询了解吧。

In the process of installing, repairing and replacing the conveyor belt, we must control the total length of the conveyor belt after bonding. It is necessary to strictly manage the adhesive construction process of conveyor belt, pay attention to the construction details and ensure the quality of joints. Come to the website for more relevant content http://www.huafengxiangsu.com Consult and understand.