What is the loading and unloading mode of rubber conveyor belt in life? Today, there are staff members of conveyor belt factory to explain to you.

　　1. 安装前检查主动轮、被动轮、张力轮是否在同一平面内。一般来说，当中心距小于1 m时，两根皮带轮的允许偏差为2- 3mm，当中心距大于1 m时，允许偏差为3- 4mm。如果偏差过大，应在安装和张紧前进行调整，以满足要求。在装卸过程中，应先松开张紧轮，或先拆下无穷大变速末端的轮盘，然后安装或拆下皮带。

　　1. Check whether the driving wheel, the passive wheel and the tension wheel are in the same plane before installation. Generally speaking, when the center distance is less than 1 m, the allowable deviation of two pulleys is 2 - 3 mm, and when the center distance is more than 1 m, the allowable deviation is 3 - 4 mm. If the deviation is too large, adjustments should be made before installation and tension to meet the requirements. In the process of loading and unloading, the tensioning wheel should be loosened, or the wheel disc at the end of infinite speed change should be dismantled first, then the belt should be installed or dismantled.

　　2. 当新皮带太紧无法装卸时，应先拆下皮带轮，再将皮带轮装上或拆下后再装上皮带轮，不得硬拆。一般连接的v形皮带应在装卸后卸下。

　　2. When the new belt is too tight to be loaded and disassembled, the pulley should be removed first, then the pulley should be mounted or disassembled, and then the epithelial pulley should be installed. No hard disassembly is allowed. The V-belt of general connection should be unloaded after loading and unloading.

　　3、三角皮带失效后应及时更换，如果一个以上三角皮带组合使用，如果其中一个或部分有效，其他几个根应同时更换，不能与新旧皮带同时使用。

　　3. The triangle belt should be replaced in time after failure. If more than one triangle belt is used in combination, if one or part of the belt is valid, the other roots should be replaced at the same time, not with the old and new belt.

　　4、输送带张紧需要调整好。皮带过紧，磨损严重，过松容易打滑

　　4. The belt tension needs to be adjusted. Too tight belt, serious wear and tear, too loose and easy to slip

　　通过对输送带厂家的讲解，您了解了橡胶输送带的装卸方法吗?我希望我们的介绍能帮助你更好的工作

　　By explaining the manufacturer of conveyor belt, do you know the loading and unloading method of rubber conveyor belt? I hope our introduction can help you work better.