1、给料口应避开滚筒或托辊的正上方；
1. The feeding port shall avoid directly above the drum or idler;
2、为减轻物料对胶带的冲击与磨损，给料方向应顺胶带的运行方向；
2. In order to reduce the impact and wear of materials on the belt, the feeding direction shall be along the running direction of the belt;
3、物料下落到胶带上的落差应尽量减小；
3. The drop of materials falling on the tape shall be minimized;
4、胶带受料段应缩短托辊间距和采取缓冲措施。为防止刮破胶带，挡料装置刮板清扫装置和卸料装置与胶带的接触部分应采用硬度适宜的橡胶板，不要采用夹有布层的胶带头；人字型橡胶输送带
4. The distance between idlers shall be shortened and buffer measures shall be taken in the material receiving section of the belt. In order to prevent the tape from being scratched, the rubber plate with appropriate hardness shall be used for the contact part between the material retaining device, scraper cleaning device and unloading device and the tape, and the tape head with cloth layer shall not be used; Herringbone rubber conveyor belt
5、每天检查托辊滚筒，发现不能正常运转的及时更换，再有检查托辊滚筒上面是否有附着物，及时清理。
5. Check the idler drum every day. If it is found that it cannot operate normally, replace it in time. Then check whether there are attachments on the idler drum and clean it in time.

6.  所有的输送带必须接成环形才能使用，也就是环形输送带，所以输送带接头的好坏直接影响输送带的使用寿命和输送线能否平稳顺畅地运行。一般输送带接头常用方法有机械接头、冷粘接接头、热硫化接头等。橡胶输送带
6. All conveyor belts must be connected into a ring before they can be used, that is, the ring conveyor belt. Therefore, the quality of the conveyor belt joint directly affects the service life of the conveyor belt and whether the conveyor line can run smoothly. The common methods of conveyor belt joint include mechanical joint, cold bonding joint, hot vulcanization joint, etc. Rubber conveyor belt
7.橡胶输送带运行速度不应大于5.0米/秒，运输块度大，磨损性大的物料和使用固定犁型卸料装置时应尽量采用低速。当橡胶输送带的运输速度超过这个速度机会影响输送带的使用寿命。所以建议使用的时候，要保证运输速度不应该超过5.0米/秒。
7. The running speed of rubber conveyor belt shall not be greater than 5.0m/s. Low speed shall be used as far as possible when transporting materials with large lumpiness and high wear and when using fixed plow unloading device. When the transportation speed of the rubber conveyor belt exceeds this speed, it will affect the service life of the conveyor belt. Therefore, it is recommended to ensure that the transportation speed should not exceed 5.0 M / s.
以上就是今天给大家讲解的详细内容，更多的精彩内容请点击我们的网站山东输送带皮带http://www.huafengxiangsu.com，我们会有更多的精彩内容等您查看.
The above is the detailed content explained to you today. For more wonderful content, please click our website Shandong conveyor belt http://www.huafengxiangsu.com , we will have more wonderful content for you to see