The use of the conveyor belt has now been developed in many industries, its transport capacity has always been praised, but have to mention a problem is that the conveyor belt after such use and change, transport capacity will be reduced, so what to do to keep its good transport capacity? Reducing its failure rate is an important measure.

　　在实际生产中，山东传送带一旦出现故障，会耽误生产时间并带来问题，如张力不足或底板不均匀，输送带受力不均等，都会极大地影响传送带的输送能力。

　　In actual production, once the failure of shandong conveyor belt, will delay production time and bring safety problems, such as insufficient tension or uneven bottom plate, conveyor belt force is not equal, will greatly affect the conveyor belt transport capacity.

　　比如：皮带打滑。因张力不足导致输送带松动，张紧装置直接关系到传送带的运行和使用寿命，特别是对于大容量、长距离的大型传送带来说，它是传送带不可缺少的组成部分。为保证带式传送带的正常运行，由于负载的变化，必须经常调整张紧辊的位置。以往一般采用固定式卷扬机张紧皮带，但只能定期张紧皮带，张紧程度往往与操作者的经验有关。张力往往过大或过小，影响传送带的稳定运行，使输送带松弛，造成打滑、不动。

　　For example: belt slip. Due to the lack of tension resulting in loose conveyor belt, tensioning device is directly related to the safe operation and service life of the conveyor belt, especially for large capacity, long distance large conveyor belt, it is an indispensable part of the conveyor belt. In order to ensure the normal operation of belt conveyor, the position of tensioning roller must be adjusted frequently due to the change of load. In the past, fixed winch tensioning belt is generally used, but it can only be tensioned regularly, and the degree of tensioning is often related to the operator's experience. Tension is often too large or too small, affecting the safe and stable operation of the conveyor belt, so that the conveyor belt relaxation, resulting in skidding, motionless.

　　解决方法：自动张紧器可以精确控制皮带张力，实时监控皮带张力，所以需要更换自动张紧器。同时，它具有良好的动态响应能力，可以在很短的时间内响应皮带张力的变化。

　　Solution: The automatic tensioner can accurately control belt tension and monitor belt tension in real time, so it is necessary to replace the automatic tensioner. At the same time, it has good dynamic response ability, can respond to the change of belt tension in a very short time.

　　再比如：底板的波动和传送带受力不均是造成压带事件。机头卸载后下半部分满载时，带式传送带受力不均，机头驱动辊打滑，造成带式传送带拉不上，下半部分皮带会被压下，传送带整体会出现波动，导致部分托辊受力。较大，托辊经常损坏；尾辊处于较低位置，既能承受皮带的水平拉力，又能承受向上的拉出力，容易造成尾辊损坏。

　　For example, the fluctuation of the bottom plate and the uneven force of the conveyor belt are caused by the pressure belt event. When the lower half of the machine head is fully loaded, the belt conveyor belt is under uneven force. The driving roller of the machine head slips, causing the belt conveyor belt can not be pulled up, the lower part of the belt will be pressed down, and the conveyor belt as a whole will fluctuate, leading to the force of part of the roller. Larger, roller is often damaged; The tail roller is in a lower position, which can not only bear the horizontal pull of the belt, but also bear the upward pull force, which is easy to cause the damage of the tail roller.

　　解决方法：通过平整巷道后梁，提升巷道底部，安装H型架增加支腿，达到平整带式传送带坡度的目的，降低运行阻力。

　　Solution: By leveling the back beam of the roadway, lifting the bottom of the roadway and installing h-frame to increase the support legs, the purpose of leveling the slope of the belt conveyor belt is achieved and the running resistance is reduced.

　　以上扁丝问题的相关内容了，讲解给我们的启示也是挺多的，比如要想降低传送带的故障率，也可以在平常使用中做好维护保养清洁的工作，保养好了还能延长它的使用寿命。那么想了解更多，就来这儿http://www.huafengxiangsu.com咨询吧。

　　The above flat wire problem related content, explain to us is also a lot of inspiration, such as to reduce the failure rate of the conveyor belt, can also do a good job of maintenance and cleaning in ordinary use, good maintenance can also extend its service life. So want to know more, just come here http://www.huafengxiangsu.com consulting.